IS-20

INSTRUCTION SHEET FOR SOMMA BAR PULLER FOR CNC TAPE LATHES

ALLOWS ONE OPERATOR TO RUN SEVERAL MACHINES

ADJUSTABLE TO PULL BARS UP TO 2-1/2" DIAMETER
BP5 PULLS BARS UP TO 3" DIAMETER
AVAILABLE IN VARIOUS SHANK SIZES TO FIT ALL MACHINES
NO SPRINGS - TENSION BUILT INTO JAWS FOR UP TO 250 LBS. PRESSURE
JAWS ARE EASILY REPLACED

EASY TO ADJUST:

- SCREW JAWS DOWN TO SLIP FIT ON BAR
- BACK OFF BAR
- ADJUST BOTH JAWS DOWN 1/4 TURN
- LOCK IN PLACE AND PULLER IS READY TO USE
- PRESSURE CAN BE INCREASED OR DECREASED BY ADJUSTING JAWS IN OR OUT

BAR PULLER PARTS
PART NO.	CAT. NO.
1. Shank 3/4" DIA.	BP1-1
1. Shank 1" DIA.	BP2-1
1. Shank 1-1/4" DIA.	BP3-1
1. Shank 1-1/2" DIA.	BP4-1
1. Shank 2" Dia.	BP5-1
2. Body	BP4-2
2. Body (for BP5 only)	BP5-2
3. Slide	BP4-3
4. Jaw	BP4-4
6. Slide Clamp Screw & Washer	VFDH0-5
8. Jaw Screw	BP4-8
9. Clamp Screw & Washer	FDH2-4
11. Adjusting Screw	BP4-11

BAR PULLER PARTS
CAT. NO.	"D"	"L"
BP1	3/4" DIA.	2"
BP2	1" DIA.	2-5/8"
BP3	1-1/4" DIA.	2-5/8"
BP4	1-1/2" DIA.	2-5/8"
BP5	2" DIA.	3-5/16"