Tap Holder Bushings

FOR CNC LATHES TOO!

00TAPSET	= 1001 thru 1051
0TAPSET	= 1101 thru 1152
2ATAPSET	= 1202 thru 1214
2BTAPSET	= 1215 thru 1227
2CTAPSET	= 1250 thru 1256

UNIQUE DESIGN -- Bushing grips the tap around three-quarters of its circumference, and fits the hole in the floating holder in the same manner. Result? More accurate fitting and line-up of tap and bushing.
*Note: Thin wall bushings have only 1 split instead of 2 and have no retainer springs.
POSITIVE OPERATION -- Entire length of bushing firmly clamps tap shank. Less chance of tap being pushed back.
HEAT-TREATED FOR LONG LIFE -- Made of quality carburizing steel and heat-treated (not merely cyanided). The only split-type bushing of its type ground after heat-treating.

SIZE OF TAP USED**	TAP SHANK DIA.	MACHINE SIZE #00 1/2 OD x 3/4 long	MACHINE SIZE #0 5/8 OD x 15/16 long	MACHINE SIZE #2 1" OD x 1-1/4 long
SIZE OF TAP USED**	TAP SHANK DIA.	CAT. NO.	CAT. NO.	CAT. NO.
#0 thru #6	.141	1001	1101	***
#7-#8-5/32	.168	1002	1102	1202
#9-#10-3/16	.194	1003	1103	1203
#12-7/32	.220	1004	1104	1204
#14-1/4	.255	1005	1105	1205
9/32	.286	1006	1106	1206
5/16	.318	1007	1107	1207
11/32	.349	1008	1108	1208
3/8	.381	1009*	1109	1209
13/32-7/16	.323	1010*	1110	1210
15/32	.354	—	1111	1211
1/2	.367	—	1112	1212
17/32	.398	—	1113	1213
9/16	.429	—	1114	1214
19/32	.460	—	1115*	1215
5/8	.480	—	1116*	1216
21/32	.511	—	1117*	1217
11/16	.542	—	1118*	1218
23/32	.573	—	—	1219
3/4	.590	—	—	1220
25/32	.621	—	—	1221
13/16	.652	—	—	1222
27/32	.684	—	—	1223
7/8	.697	—	—	1224
15/16	.760	—	—	1225*
1"	.800	—	—	1226*
1-1/16-1-1/8	.896	—	—	1227*
PIPE TAP BUSHINGS
1/16	.312	1050	1150	1250
1/8	.437	1051	1151*	1251
1/4	.562	—	1152*	1252
3/8	.701	—	—	1253
1/2	.688	—	—	1254
5/8	.813	—	—	1255
3/4	.907	—	—	1256*
RETAINING SPRINGS FOR ABOVE BUSHINGS
		MB00-RS	MB0-RS	MB2-RS

** NOMINAL OD OF THREAD THAT TAP WILL CUT.
*** FOR TAPS SMALLER THAN #7 USE #0 TAP HOLDER AND TA02 ADAPTER